DataPower VM Setup

STEPS FOR SETTING DataPower Virtual Machine in Local PC

Required – DataPower VM copy, VMWare Player

Configure VM settings based on system and network configuration.

Start VM Player and follow the below steps.

Login: admin
password: admin
Enter Disaster Recovery mode [yes/no]: no
Enter Common Criteria Compatibility mode? [Yes/no]: no
Please enter new password: provide-password
Please re-enter new password to confirm: provide-password
Do you want to run the Install Wizard? [Yes/no]: y

Step 1
Do you want to configure network interfaces? [y]: y
Do you have this information? [y]: y
Do you want to configure the eth0 interface? [y]: y
Do you want to enable DHCP? [y]: y
Do you want to configure the eth1 interface? [y]: y
Do you want to enable DHCP? [y]: y
Do you want to configure the eth2 interface? [y]: y
Do you want to enable DHCP? [y]: y
Do you want to configure the eth3 interface? [y]: y
Do you want to enable DHCP? [y]: y

Step 2
Do you want to configure network interfaces? [y]: y
Do you want to configure DNS? [Y/n]: n

Step 3
Do you want to define unique system identifier for the appliance? [Y]: y
Note: Give any appropriate unique system identifier
Enter a unique system identifier: VijayDP

Step 4
Do you want to configure remote management access? [y]: y
These configuration require the IP address of the local interface that manage the appliance.
Do you have this information? [y]: y
Do you want to enable SSH? [y]: y
Enter the local IP address [0 for all]: 0
Enter the port number [22]:
Note: Just enter to accept default
Do you want to enable WebGUI access [y]: y
Enter the local IP address [0 for all]: 0
Enter the port number [9090]:
Note: Just enter to accept default

Step 5
Do you want to configure a user account that can reset passwords [y]: y
Note: This is optional, but you can provide userid and password (keep note of this detail)

Step 6
Do you want to configure the hard disk array? [y]: y

Do you want to continue? [y]:
Enter name for the file system [ondisk]: vj_local

Step 7
Do you want to review the current configuration? [y]:
Do you want to save current configuration? [y]: y
Overwrite previously saved configuration? [y/n]: y
Xi52 (config) # show interface